Allied Manta Guía de instalación descargar pdf (Pagina 7)

Introduction

Manta Hardware Installation Guide V4.1.0

continued from last page

V4.1.0 24.06.11 Power over Ethernet (PoE)

• Added PoE voltages in Figure 25: MANTA: Camera I/O

connector pin assignment on page 47

• Added note about IEEE 802.3at in Chapter Camera

interfaces on page 43

• Added PoE in Figure 24: Example: Rear view of MANTA

camera (left: no PoE; right: PoE capable) on page 44

• Added PoE in Table 3: Rear view of AVT Manta cameras

(HIROSE and Gigabit Ethernet RJ-45 port) on page 44

• Added PoE in Chapter Overview hardware installation on

page 26

• Added PoE in Chapter Connecting camera to PC or laptop

on page 33

• Added PoE in Chapter Gigabit Ethernet port (MANTA) on

page 45

• Added description of third LED: see Figure 24: Example:

Rear view of MANTA camera (left: no PoE; right: PoE

capable) on page 44 and Table 6: Status LED3: PoE

cameras only and Manta G-145-30fps / Manta G-201-30fps

(non PoE) on page 45

• Added Chapter MANTA PoE input block diagram (incl.

Manta G-145-30fps/201-30fps) on page 49

• Added Chapter MANTA PoE delay and minimum pulse width

on page 50 (same values as non-PoE Manta cameras)

• Added note that higher external values will increase the

delay times: see Chapter Test conditions on page 52.

• Added cross reference to: Application Note: Hardware

Selection for AVT GigE Cameras: on page 11

Manta board level

• Deleted (PWR output on demand) at pin 2, see: Figure 33:

MANTA board level camera: I/O pin assignment on page 53

to be continued on next page

Version Date Remarks

Table 1: Document history

1 2 3 4 5 6 7 8 9 10 11 12 ... 60 61

Sin comentarios

Allied Manta Guía de instalación Pagina 7